Peter from West Networks gives a quick demonstration of setting up the IP67 RJ45 plug for the Peplink HD1 and HD2 Dome.

Steps:

1. Pass the Un-crimped Wire through all 4 pieces of the Plug (Base, Silver Nut, Grey Seal, Black Cap)
2. Crimp Wire
3. Slide Silver Nut over Base
4. Insert Grey Seal piece into Base (This seals the gap between the wire and base)
5. Gently screw Black end cap over Base (do not fully tighten)
6. Slide Crimped Wire end fully into the Base, align Crimped wire with the notch in the Base
7. Tighten Black Cap until the Grey Seal is visible.